Gear GeeksGaming

Thunderbolt 4 dock max refresh rate at 1440p and 4K

One 1440p 240 Hz screen fits through a Thunderbolt 4 dock at 8-bit colour, with 5% to spare. 4K 144 Hz does not fit without DSC compression, and neither do two 1440p 240 Hz screens. Why the 40 Gbps on the box never reaches one screen, and what CalDigit, Dell and Plugable promise for their own docks.

MonitorsUpdated 7 min read

Yes for one 1440p 240 Hz screen, if the laptop sends DisplayPort at its top speed. No for 4K 144 Hz, unless DSC compression is on. A Thunderbolt 4 or USB4 dock gives each screen at most one DisplayPort 1.4 link, which carries 25.92 Gbps of picture. 1440p 240 Hz needs 24.62 Gbps at 8-bit colour, so it fits with 5% to spare. 4K 144 Hz needs 31.35 Gbps, so it does not. Two screens share the same cable, and the dock's own ports can cap things lower still.

What a Thunderbolt 4 dock does with video

A dock is a box on one cable that gives a laptop more ports: screens, USB, network and power. Thunderbolt 4 and USB4 are the two names for the fast kind of USB-C link these docks use. Both run at up to 40 Gbps, though VESA gives a USB4 laptop a "Minimum of 2 lanes at 10 Gbps", which is 20 Gbps. Intel's Thunderbolt 4 announcement calls it compliant with "USB4, DisplayPort and PCI Express".

The key word is tunnelling. The laptop does not send pictures as their own signal. It packs a normal DisplayPort link into the 40 Gbps stream, next to USB and other data. The dock unpacks it and sends it out of a display port. VESA's 2019 USB DevDays slides say every USB4 host and hub "must support DP Protocol Tunneling". The hub side has a "DP OUT Adapter" that sends the tunnelled traffic on to the screen.

So each screen is still on a DisplayPort link, with a lane count and a link rate. HBR3 (High Bit Rate 3) is the fastest rate of DisplayPort 1.4: 8.1 Gbps a lane. Two bits in ten are encoding overhead, so four HBR3 lanes carry 25.92 Gbps of picture. The Linux Thunderbolt driver lists that as the largest entry in its HBR table: "8100, 4", or "25920 Mb/s". It also notes that tunnelling strips the encoding, so the 25.92 Gbps is what a tunnel actually costs.

On a 20 Gbps USB4 laptop the ceiling is lower. The Linux driver keeps a 10% guard band on each link, so 18 Gbps is left, and the biggest tunnel that fits is four HBR2 lanes: 17.28 Gbps. That carries 1440p at up to 174 Hz, so 240 Hz needs DSC there.

one screen's ceiling = 8.1 x 0.8 x 4 = 25.92 Gbps (four HBR3 lanes) whole cable = 40 Gbps, less a guard band a mode needs = pixel clock x 24 (8-bit) or x 30 (10-bit)

DSC (Display Stream Compression) squeezes the picture so a bigger mode fits the same link. It only works if the laptop, the dock path and the monitor all support it. Plugable warns that HBR3 and DSC "are not required to be implemented on all computers with USB4 or Thunderbolt 4 capability".

Worked case: a 1440p 240 Hz monitor on a CalDigit TS4

Take a Windows laptop with Thunderbolt 4 and HBR3 output, and a CalDigit TS4, which has one DisplayPort 1.4 port and Thunderbolt 4 ports. Plug a 1440p 240 Hz monitor into the DisplayPort port.

At standard reduced blanking, 1440p 240 Hz has a 1025.8 MHz pixel clock. At 8-bit that is 24.62 Gbps. The tunnel carries 25.92, so the mode uses 95% of it and fits without DSC. At 10-bit it needs 30.77 Gbps, so 10-bit needs DSC. That is the same result as a plain DisplayPort 1.4 cable, because it is the same link.

Now add a second 1440p 240 Hz monitor. The pair needs 49.24 Gbps at 8-bit. That is more than the whole 40 Gbps cable, before USB takes any share. CalDigit's refresh rate page lists the TS4 at "Both up to 240Hz" for two 1440p screens. By the arithmetic, that pair only runs with DSC.

Swap in a 4K 144 Hz monitor instead. It needs 31.35 Gbps at 8-bit, so it needs DSC at about 1.2:1. CalDigit lists 4K "up to 144Hz" on the TS4. It also says some 4K 144 Hz monitors ship with DSC off, and "You will need to enable DSC support from monitor's OSD menu manually".

What each dock maker promises

The tunnel sets the ceiling. The dock's ports, and what the maker has tested, can sit below it. "Our ceiling" is derived from the 25.92 Gbps tunnel, or from the port's own standard when that is lower.

Maker-stated display limits for Thunderbolt docks, against the derived ceiling for one screen. Pixel clocks at CVT reduced blanking v2, full RGB colour.
DockMaker-stated limitsOur ceiling for one screen
CalDigit TS41440p up to 240 Hz, two screens both up to 240 Hz. 4K up to 144 Hz.1440p 240 Hz fits at 8-bit (24.62 of 25.92 Gbps). Two at 240 Hz, and 4K 144 Hz, need DSC.
CalDigit Element Hub1440p up to 240 Hz, two screens both up to 240 Hz. 3440 x 1440 up to 180 Hz. 4K up to 144 Hz.3440 x 1440 at 180 Hz fits at 8-bit (23.87 Gbps). 4K 144 Hz needs DSC.
CalDigit TS3 Plus1440p up to 144 Hz, two screens both up to 144 Hz. 3440 x 1440 up to 144 Hz, two at 120 Hz.The maker's limit is the cap. 1440p 144 Hz needs 14.08 Gbps.
Dell WD22TB4Thunderbolt laptop with HBR3: one 4K 60 Hz, or two 4K 60 Hz on the two DP 1.4 ports. No mode above 60 Hz listed.Dell's link split: 25.92 Gbps plus 6.48 Gbps. One HBR3 lane caps 1440p at 68 Hz.
Plugable TBT4-UDZTwo HDMI 2.0 and two DisplayPort 1.2 outputs. Windows with HBR3 and DSC: up to four 4K 60 Hz.A DP 1.2 port caps 1440p at 174 Hz. An HDMI 2.0 port caps it at 147 Hz.

The Element Hub's 3440 x 1440 at 180 Hz needs 23.87 Gbps at 8-bit, so it fits one tunnel without DSC. The TS3 Plus stops at 144 Hz by CalDigit's own figure, well inside the link: 1440p 144 Hz needs 14.08 Gbps. The DP 1.2 and HDMI 2.0 caps come from our DisplayPort 1.2 page and our HDMI 2.1 page, which gives the TMDS limit. CalDigit adds one condition to every row: "Your system including OS, GPU, drivers, cables and monitors must support above resolution and refresh rates."

How two screens split the cable

Each screen gets its own tunnel, and all of them share the 40 Gbps link. The Linux driver leaves a 10% guard band on each link ("Leave 10% guard band"), so about 36 Gbps is left for every tunnel together. Two full HBR3 tunnels would need 51.84 Gbps, which does not fit.

Dell's WD22TB4 table shows one way a dock splits it. For a Thunderbolt laptop with HBR3 it gives "HBR3 x 4 lanes + HBR3 x1 - 32.4 Gbps". That is a full 25.92 Gbps link plus a one-lane link of 6.48 Gbps. The small link carries 1440p at up to 68 Hz or 1080p at up to 118 Hz, by the same arithmetic. That matches Dell's own rows: a screen on the dock's Thunderbolt port beside a 4K screen is listed at 1440p 60 Hz.

Dell also lists two 4K 60 Hz screens on its two DisplayPort ports. Together they need 25.08 Gbps, just under one 25.92 Gbps link. When two screens share one link, that is MST, and our daisy chain page works out which pairs fit. A 1440p pair stops at 128 Hz there without DSC.

For an HBR2 laptop, Dell gives "HBR2 x 8 lanes - 34.5 Gbps": two full HBR2 links of 17.28 Gbps. Each carries 1440p at up to 174 Hz, so an older laptop can still run a fast 1440p screen through the dock.

"40 Gbps" and "two 4K displays": why both mislead

The 40 Gbps figure invites the idea that one screen can use all of it. It cannot. The tunnel is a DisplayPort 1.4 link, so one screen stops at 25.92 Gbps. That gives the same ceilings as a DisplayPort 1.4 cable: 1440p at 251 Hz and 4K at 120 Hz at 8-bit, 205 Hz and 97 Hz at 10-bit.

Intel's figure pulls the other way. Its announcement lists "Support for two 4K displays or one 8K display" for Thunderbolt 4, and calls it double "the minimum video and data requirements of Thunderbolt 3". That is a floor every Thunderbolt 4 laptop must meet, not a ceiling. Dock pages that only list 4K 60 Hz, like Dell's, are stating what they promise, not what the link allows.

Where this stops applying

Every figure assumes CVT reduced blanking v2 and full RGB colour. Monitors ship their own timings, so 1440p 240 Hz at 8-bit, at 95% of the link, can go either way. The guard band and the tunnel sizes are read from the Linux driver. Windows and macOS do not publish theirs, and docks split the cable in their own ways, as Dell's table shows. A dock on a USB-C port without Thunderbolt or USB4 falls back to DisplayPort Alt Mode. Dell's table gives that case two HBR3 lanes, 12.9 Gbps, enough for 1440p at up to 133 Hz. Macs have their own limits: CalDigit says base M1, M2 and M3 Macs "can only support ONE external display", and Plugable says Apple Silicon has no MST. Thunderbolt 5 and the faster UHBR links of DisplayPort 2.1 are not covered. This is arithmetic and maker data, not a test of any dock.

What a Thunderbolt 4 dock carries

  • Each screen gets at most one DisplayPort 1.4 link inside the cable: four HBR3 lanes, 25.92 Gbps. The 40 Gbps is shared, never given to one screen.
  • 1440p 240 Hz fits at 8-bit (24.62 Gbps). 10-bit, 4K 144 Hz and two 1440p 240 Hz screens need DSC.
  • The second screen may get far less. Dell's WD22TB4 gives a 25.92 Gbps link plus a 6.48 Gbps one.
  • The dock's ports can cap you lower: DP 1.2 stops 1440p at 174 Hz, HDMI 2.0 at 147 Hz.
  • HBR3 and DSC are optional on Thunderbolt 4 and USB4 laptops, so check the laptop too.

Sources

Frequently asked questions

Can a Thunderbolt 4 dock run 1440p 240 Hz?

Yes, on one screen at 8-bit colour, if the laptop sends DisplayPort at HBR3. The mode needs 24.62 Gbps and one DisplayPort link inside the cable carries 25.92. At 10-bit it needs 30.77 Gbps, so it needs DSC. CalDigit lists 1440p up to 240 Hz on its TS4 and Element Hub.

Can a Thunderbolt 4 dock run 4K 144 Hz?

Only with DSC. 4K 144 Hz needs 31.35 Gbps at 8-bit, and one tunnelled DisplayPort link carries 25.92. With DSC at about 1.2:1 it fits. CalDigit lists 4K up to 144 Hz on the TS4 and says some monitors need DSC switched on in their menu.

Thunderbolt 4 is 40 Gbps, so why can't one screen use it all?

The dock does not turn the 40 Gbps into one big video pipe. It carries whole DisplayPort links inside it, and each one is at most four lanes at HBR3: 25.92 Gbps of picture. That is the same ceiling as a DisplayPort 1.4 cable.

Can a Thunderbolt 4 dock run two 1440p 240 Hz monitors?

Only with DSC. Two 1440p 240 Hz screens need 49.24 Gbps at 8-bit, more than the whole 40 Gbps link. CalDigit lists both screens up to 240 Hz on the TS4, which is only possible with compression.

Why is my second screen stuck at 60 Hz on my dock?

The second screen often gets a much smaller link. Dell's table for its WD22TB4 dock gives a Thunderbolt laptop four HBR3 lanes plus one more HBR3 lane, 32.4 Gbps in all. One HBR3 lane carries 6.48 Gbps, which is enough for 1440p at up to 68 Hz.

Sourcing. DisplayPort tunnelling as a USB4 host and hub requirement is from VESA's USB DevDays 2019 presentation. The per-tunnel maximum of four HBR3 lanes (25.92 Gbps) and the 10% guard band on each link are read from the Linux kernel's Thunderbolt driver (tunnel.c and tb.c). Intel's Thunderbolt 4 minimum is from its July 2020 announcement. Dock limits are manufacturer-stated, from CalDigit, Dell (WD22TB4 user guide, archived copy) and Plugable. Pixel clocks are derived at CVT reduced blanking v2, the same clocks as our DisplayPort 1.4 and USB-C pages. Checked November 21, 2026. Found an error? Send a correction.